請教IT幫各位先進們
跟華電申請的數據專線2M 進Router後 Show interface 看到的速度只顯示1544 kbit 正常嗎??
實際測試速率時並不是完全每次都能全速跑到2M
確認過 Running config 並沒有設定速率
請問這樣的狀況正常嗎
還是得手動去設定兩端的Router Interface 的速率

Router#sh interface Serial0/0/0
Serial0/0/0 is up, line protocol is up
Hardware is GT96K Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 53/255, rxload 2/255
Encapsulation PPP, LCP Open
Open: CDPCP, IPCP, loopback not set
Keepalive set (10 sec)
Last input 00:00:58, output 00:00:07, output hang never
Last clearing of "show interface" counters 15w5d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 7362168
Queueing strategy: weighted fair
Output queue: 0/1000/64/7362168 (size/max total/threshold/drops)
Conversations 0/85/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1158 kilobits/sec
5 minute input rate 15000 bits/sec, 17 packets/sec
5 minute output rate 326000 bits/sec, 30 packets/sec
215769048 packets input, 2707058720 bytes, 0 no buffer
Received 0 broadcasts, 614 runts, 8 giants, 0 throttles
165060 input errors, 165060 CRC, 17774 frame, 1588 overrun, 0 ignored, 28146 abort
245486271 packets output, 853329930 bytes, 0 underruns
0 output errors, 0 collisions, 2346 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up